Views: 1 Author: Site Editor Publish Time: 2024-06-05 Origin: Site
One of the most important issues that we cannot ignore every day is the regular cleaning and protection of the metering pump. The following metering pump manufacturers will tell us about the correct way to clean the metering pump! Flush with clean water for about 10 minutes, then flush for about 5 minutes, and then make sure that the water in the pipe has been drained before starting the disassembly action to reduce the risk.
Turn off the power supply of the diaphragm metering pump and remove all valves (during the disassembly process, it is still necessary to pay attention to the residual chemicals and moisture to avoid injury or damage to the power supply and other related equipment). Flush the valve and its parts with clean water. Check the parts for defects, deformation, cracks and other conditions, if any, please replace them.
Reinstall all valves as they are. Soak in clean water for 5 minutes to test (if there are crystals, please use crystal thinner for about 10 minutes, then change to clean water for about 5 minutes). In the process of protecting and disassembling the dosing and metering pump, please pay attention to a certain order, especially the hydraulic cylinder parts and gearbox.
To disassemble the hydraulic cylinder assembly, first remove the pipes and fittings connecting the check valve; Remove the pump head, loosen the diaphragm (contact the manufacturer at this time), and then remove the hydraulic cylinder head from the gearbox; Remove all parts of the tappet assembly in the following order: remove the spring seat boy; Take out the spring seat, spring and tappet in sequence; If it is necessary to replace the composite bearing mill, please remove it and replace it with the same type.
content is empty!
content is empty!